AB-6529
9
Direct screw mounting
Fig. 7 shows the mounting dimensions of Infilex GD directly on a mounting surface, with screws.
To mount Infilex GD with screws, the screw tabs (Part No. 83165861-001, with separate order required) are required. Mount
and fix Infilex GD on the mounting surface with M4
8 screws. (1 screw tab and 2 screws for 1 basic unit/module are required.)
Lengthwise mounting
Incorrect mounting: Crosswise, face-up/face-down*
2
Notes:
1 Hatched area shows the maintenance space.
2 ‘n’ indicates the number of I/O module, UT module, integral type Operator Panel, and/or SAnet I/F module assembled with Infilex GD basic
unit.
3 Do not mount Infilex GD in the crosswise direction (basic unit positioned above or below the assembled modules). Do not mount it with the
front surface facing upward or downward, either.
The width of Infilex GD may vary depending on the number of an I/O module, UT module,
integral type Operator Panel, and/or SAnet I/F module to be assembled. Their outside
dimensions are the same.
Width of Infilex GD = One module (30 mm)
n (quantity) + Infilex GD basic unit (60 mm)
Notes:
Panel mount type Operator Panel is not directly assembled with Infilex GD. To connect it to
Infilex GD, a UT module is required.
For the dimensions of panel mount type Operator Panel, please refer to
Specifications/Instructions of Operator Panel (AB-6546).
For details of I/O modules and user interface modules that can be assembled with Infilex GD,
refer to Specifications/Instructions of I/O modules and user interface modules (AB-6527).
I/O module (mm)
Figure 7. Mounting dimensions: Direct screw mounting (mm)
30
DIN rail holder
Pull down the DIN rail holders.
Screw tab Part No. 83165861-001
Rear
side
Screw tab
50
20
30 45 30
30
35
140
35
154
7
To attach the screw tab,
insert the screw tab into
the slit provided on the
rear side of Infilex GD.
1
Infilex GD
basic unit
60 + 30
n*
2
I/O modules, UT module,
integral type Operator Panel,
SAnet I/F module
Insert.
Vertical direction
Infilex GD
basic unit
