AB-5963
2
Safety Instructions
Please read instructions carefully and use the product as specified in this manual. Be sure to keep this manual near by for ready
reference.
Usage Restrictions
This product is targeted for general air conditioning. Do not use this product in a situation where human life may be affected. If
this product is used in a clean room or a place where reliability or control accuracy is particularly required, please contact Azbil
Corporation’s sales representative. Azbil Corporation will not bear any responsibility for the results produced by the operators.
WARNING
•
Do not disassemble the product. Disassembly may result in electrical shock or equipment damage.
CAUTION
•
Installation and wiring must be performed by qualified personnel in accordance with all applicable safety
standards.
•
This product must be operated under the operating conditions (power, temperature, humidity, vibration, shock,
installation position, atmospheric condition, etc) specified in this manual to prevent equipment damages.
•
This product must be operated within its rated operating ranges specified in this manual. Failure to comply will
cause equipment damages.
•
All wiring must comply with local codes of indoor wiring and electric installation rules.
•
This product does not have a power switch. Be sure to install a power circuit breaker for the power source.
•
Lightning protection based on the regional characteristics and the building structure is necessary to minimize
lightning damages to the product.
•
Always disconnect power source before performing any wiring to prevent equipment damages.
•
Use crimp terminal lugs with insulation for electric wires to be connected to the product screw terminals.
•
Make sure all the wires are tightly connected to prevent heat generation or equipment malfunction. Insufficient
tightening of the screw terminals also can cause inaccurate measurement.
•
Leave vacant terminals unconnected to prevent product damage.
•
Do not step on the product. External force can damage the product.
•
If more than the rated power supply voltage is applied, product replacement is required for safety.
•
Do not use two-away radio or any wireless device within 3 m radius of the product. It may lower the product
sensing accuracy.
•
Carefully press the rubber packing. Personal injury can be caused when your fingers holding the tool slip.
•
Dispose of this product as an industrial waste in accordance with your local regulations. Do not reuse all or part of
this product.
IMPORTANT:
•
When the product is faulty, reduced output may cause over-humidification. Provide safety measure for the
controller in connection.
•
Product sensing accuracy is preset before shipment. Output of the product, used even in normal air, may be
shifted depending on the operating conditions. Periodic inspection therefore may be required.
•
Corrosive gas or organic solvent may damage the product or shift the product output. Before using the product
in abnormal atmosphere, consult with Azbil Corporation’s sales personnel.
Trademark information:
FP3 is a trademark of Azbil Corporation in Japan or in other countries.