5
Assembly
STEP 1:
Attach post with burner
assembly onto heater
housing and line up the
mounting bracket with the
screw hole. Secure them with
4pcs 3/16" stainless bolts.
Secure the bracket on the
regulator to the sidewall
with 1pc M5X12 bolt ,1
pc nut M5 and 1pc
washer. Tighten the bolt
and nut on bracket.
Keep the access panel
open.
For additional assistance or service,
please call: 888-775-1330.
STEP 2:
Attach ring weight with
4pcs M6X20 bolts
thought the base to the
heater housing.
STEP 4:
Insert ends of wire
guard into holes in
the post with burner
assembly flange and
put 3pcs washers into
the top of support bolt.
STEP 3:
Put 3pcs reflector spacers into the hole in
emitter using 3pcs nuts to secure the reflector
spacers inside of the emitter.Put M6X60
bolt through the emitter hole into the top
of the emitter,using 1pc nut to secure the bolt.
Attach emitter assembly to post using 4pcs
bolts and washers.
STEP 5:
Attach reflector to emitter
assembly,using 3pcs nuts.
STEP 6:
Put reflector cap through the
M6X60 bolt using finial to secure it.