Check if all the screws are intact and secured and tighten or replace them where needed. Check all metal
parts of the device for any signs of corrosion. If corrosion is found, the device needs to be checked
thoroughly.
DMX terminator
In DMX mode, it’s standard practice to place a terminator at the end of a DMX circuit. A DMX terminator is an
electrical termination consisting of a 120 Ohm resistor, that’s placed between the second and third pin to
eliminate possible data reflections. Data reflections can cause strange behaviour in DMX-controlled devices.
DMX-terminators are sold separately but you may yourself decide to solder a 120 Ohm resistor between the
second and third pin of a standard male XLR connector.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Revision date and author's initials: -
