Operation and mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During startup, ‘AYRA’ will be shown on the display, which means the device is not ready to be operated.
Once the device has fully started up, it will jump to the last-used mode. Operation modes and other settings
shown on the display can now be adjusted or changed by means of the menu buttons.
The device has no automatic DMX signal detection. If you want to use the device in DMX mode, manually
select DMX mode and optionally change the starting address. For new devices, this will normally be DMX
address 001. Of course, you can change the DMX address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press
'Enter' to confirm an adjustment or select a function, use ‘Up’ and ‘Down’ to change amounts and ‘Menu’ to
go back to the menu. By holding the ‘Menu’ button down for 2 seconds after saving a specific setting, the
device will return to operation mode and adopt the setting. This will also be done after any changes in the
operation mode or DMX address. This operation is not always necessary, considering the device
automatically does this after a new setting is confirmed.
The menu contains the following options and functions.
display
Mode
Function
A00X
DMX Address Configuration
Address A001 … A512
C000
Stand-Alone Settings
CD00-CD99 (0-100% Dimmer)
CF00-CF99 (Strobe off-slow-fast)
CN0X
Quick Stand-Alone Selection
CN01 100% Output level
CN02 66% Output level
CN03 33% Output level
AUTO
Automatic Program
AU00-AU99 (Slow-fast)
SLAV
Slave Mode
‘Enter’ will automatically set the device as slave.
If not set to slave, the device will operate as
Master.
SOUN
Sound-Controlled Mode with
adjustable sensitivity
S000-S099 (Not sensitive – Very sensitive)
1CH / 2CH
DMX Channel Mode Selection
1CH = 1-Channel DMX-mode
2CH = 2-Channel DMX-mode
You'll find an explanation of the various functions below:
ADDR:
With this function, you can determine the DMX start address of the device. Set it channel 001, and
the device will read DMX channel 1. Set it to channel 003, then the device will read DMX channel 3, etc.
C000:
This device can be used as a stand-alone unit and thanks to the possibility to separately set the
dimmer intensity and stroboscobe speed, you can decide how you want the device to behave within your set-
up. Separately adjust the dimmer and flashing intensity.
AUTO:
This device features an automatic show mode. This demo mode shows different programs and
effects. The speed setting is adjustable.
SLAV:
The Master-Slave mode is designed to sync multiple devices. A copy of the internal program is sent
to the daisy-chained devices so that each one projects the same effect. The master-slave function works by
means of standard 3-pin XLR cables. The only difference is that the first device in the chain does not receive
DMX input. In Slave 1 mode, the device will copy the exact signal directly from the Master.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019RV
Revision date and author's initials: -
