Installation and connection requirements
The Ayra ComPar 2 is a versatile product that can be used in many ways. To use this device as intended and
to be sure that it is used in a safe way, the following requirements must be met during the setup, installation
and connection.
Installing the system in a standing position
The ComPar 2 is used for lots of applications and can be placed directly on a flat surface such as a table,
floor or counter. Please ensure that the device is positioned safely and the power cord is installed properly.
Accidents may happen if the power cord is hanging freely and can be pulled by small children, causing the
device to fall down. Install the device securely and contact your local dealer or a skilled technician for the
best installation advice for permanent and mobile setups.
The device can be placed in a standing position for uplighting purposes, using either the integrated double
bracket or the rubber feet.
Installing the fixture in a suspended position
The ComPar 2 is equipped with a mounting bracket that makes it possible to install the device suspended
from a ceiling, wall or beam. Mounting hardware is not included, but available at your local hardware store.
Please make sure to select the right mounting hardware for the material. For example, wooden beams
require other hardware than a brick wall.
A safety cable must be used to secure the device if the device is installed in a suspended position. A safety
cable is not included, but can be purchased at your local dealer. The bracket knobs will hold the fixture if it
falls, so looping the safety cable through the mounting bracket is sufficient. If the mounting hardware should
fail for any reason, the device must not be permitted to fall more than 30 cm and the safety cable must be
able to carry 10x the weight of the unit.
Light source
The ComPar 2 uses 54 powerful SMD RGB LEDs to create an immense number of colours. The light source
cannot be replaced by the user. The device does not require cool down time after use before it is
transported. The ComPar 2 uses convection cooling and is not equipped with cooling fans. If the device is
used in a fixed installation, it can be disconnected from the power source or turned off. There are no fans
installed to cool the lamp, so a standby setting before shutdown is not required.
Do not look at the device's light source from short distance when it is in use. The human eye will adjust to the
bright beams and possibly create temporary blind spots. These will disappear after a short period of time and
will not cause permanent damage to the eye or permanent loss of vision, but can cause disorientation and
inconvenience.
To protect the user and the device from damage and/or injury, a plastic lens is placed in front of the SMD
LEDs. It is therefore not possible to actually touch the SMD LEDs. The PCB it is soldered on for your
protection. If the lens is severely damaged or grants direct access to the PCB for any reason, the device
should not be used and disconnected from the mains.
Spare parts
This unit has no user-serviceable parts inside. If internal components sustain damage, contact your local
dealer or a specialised technician in order to repair the fixture.
Cleaning:
Clean the housing of the fixture frequently with a damp cloth, to remove dust and/or dirt.
WARNING:
Always disconnect the fixture from your wall outlet or other power supply and let the fixture dry
before reconnecting it. This prevents possible electric shocks.
The lenses can be cleaned with a non-aggressive glass cleaning solution, but this is not recommended. Ayra
advises cleaning the mirror and lens with a fine brush, while removing dust and/or dirt with a vacuum cleaner.
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 04-11-2015 RV Revision date + author initials:
