Installation and maintenance
Installing the system in a standing position (right side up)
The ComPar KIT 1 and 2 are equipped with a 35 mm stand adapter, which
makes it possible to position the system on a standard loudspeaker or
lighting stand. A screw knob is attached to the adapter, used to tighten the
system so it is unable to turn around. This also prevents unwanted rattle
noise caused by speaker vibrations, and possible instability as tube
diameters of stands may always vary slightly.
Installing the fixture in a standing position (inverted)
It is possible to use the LED projectors as a floor spot system, for example
when you want to use them for uplighting purposes. For this feature, use the
screw knobs at the top of the system and mount a floor stand on each side (floor
stand not included). Invert the display status by using the menu option, for easy
reading of values. After this, flip the system and position the bar as you wish.
NOTE:
You may need to replace the screw knobs for standard bolts, as the
height of floor stands may vary.
Installing the fixture in a hanging position
When installing the system in a hanging position (for example, on a truss
construction), detach the screw knobs and install proper G-clamps or half couplers (not included).
NOTE:
When installing the system in a hanging position, the following list of safety precautions must be met:
- Use at least two hanging points (clamps), for optimal stability and safety.
- Use at least one (recommended amount: 2) safety cable(s), capable of holding 3x the weight of the system.
Safety cables must be installed in such a way that it is impossible for the system to fall down when one of the
two mounting points breaks.
- It is prohibited to install the system by using only safety cables or chains!
Warranty is void when any of the above safety precautions are not met. Ayra can not be held responsible if
any damage or injury occurs due to improper use of the system.
Transport
When using this fixture in mobile setups, provide sufficient protection during transport. Always use the
provided transport bags to protect the system and included lighting stand.
Replacing the internal fuses
First check whether a failing power supply may be the cause of malfunction. When you suspect that one of
the internal fuses is broken, the fuse can be replaced by removing the fuse cover, located on the rear of the
fixture, near the power inputs, outputs and control menu.
WARNING:
Before checking the fuse, always disconnect the fixture from your wall outlet or any other power
supply to prevent electric shocks.
Always replace a broken fuse with a fuse that has the same type and rating. After the fuse has been
replaced, always close the fuse-cover. Reconnect the fixture to your power supply and check whether the
problem is solved. When this does not solve your problem, contact your local dealer for help.
Spare parts
This unit has no user serviceable parts inside. When any damage to internal components occurs, contact
your local dealer or a specialized technician in order to repair the fixture.
Cleaning:
Clean the housing of the fixture frequently with a damp cloth, to remove dust and/or dirt.
WARNING:
Always disconnect the fixture from your wall outlet or other power supply and let the fixture dry
before reconnecting it. This prevents possible electrical shocks.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 3.0
Creation date + author initials: 30-07-2013 RV Revision date + author initials: 11-02-2014 RV
