Hour
Using time of light
Fixture hours,0 ~ 9999
Displays the run time of the
fixture. Used by rental
companies to determine
service/maintenance
intervals.
UERS
version
Software version,Ver XXX
Firmware software version,
not upgradeable by users
Foot controller features:
Suspend
Blackout of the unit (no light whatsoever)
Menu/up
Strobe
1.
Synchronous strobe in white
2.
Sound strobe in white
3.
Sound strobe in color
Select color
-
Red
-
Green
-
Blue
-
Red + Green
-
Red + Blue
-
Green + Blue
-
Red + Green + Blue
-
Color change by
sound
Select Show
1 – 8
Full
Full white blinder mode when pressed, regardless of selected mode. Back to previous mode
when released.
Working modes:
Stand-alone (automatic):
Select one of the internal programs, which will activate and run in a continuous
loop.
Music controlled mode (sound-active):
Activate the internal microphone by using the display and set the
right sensitivity for optimal music-controlled shows. Select one of the predefined shows. The show will
change step by step when sound is detected.
Master/slave mode (sync-mode):
Connect two or multiple ComPar KIT systems with a standard 3p male to
3p female XLR cable. The first system will act as a master fixture, the second system will mimic the actions
of the first system, thus creating synchronized effects.
To ensure that this function works properly, use the DMX OUT connector of the first system and the DMX IN
connector of the second system. Set the second system to Slave 1 or Slave 2 mode (synchronized or
mirrored mode). Connecting more than 1 slave is possible, with a maximum of 16 units.
The Master/slave mode also works when using the included foot controller. Connect the foot controller to the
first fixture with the 5P connector, then feed the signal through from fixture to fixture with the DMX in- and
outputs.
DMX mode:
The most extended working mode, as this function gives you the ability to control the system
with a standard DMX-512 controller, using the 3p DMX in- and outputs. Select one of the several channel
modes and set the right starting address. After this, you have full control over the system with your DMX
controller.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 3.0
Creation date + author initials: 30-07-2013 RV Revision date + author initials: 11-02-2014 RV
