150-7000-001
7
There are three mounting holes in the back of the Monitor for the ball mounting plate.
Take care not to strip the screw holes or over tighten. (Figure )
• Line up one of the ball mounting plates on these three holes (Figure )
• With three (3) M x 10 counter-sunk stainless screws attach this mounting plate to
the back of the display.
• Mount the second ball mounting plate where the Monitor shall be installed
• Insert each ball into the RAM arm
• Lightly tighten the arm around the balls using the T-knob on the arm (Figure 2, )
• Adjust the Monitor to the viewing preference, and
• Tighten the T-knob to hold the Monitor in position.
It is recommended the remaining ball be mounted on a flat surface. Because of the
various surface substrates the Monitor shall be mounted on, the installer shall provide
the screws to mount the other ball.
Panel Mount
The mounting hardware packet is included with the unit accessories in the shipping
box. This packet includes four () threaded screws (approximately 7.6 cm [3”] long),
four () Nylock nuts and four () flat washers. For installation, there are four tapped
mounting holes on the four corners of the unit’s rear panel.
7
