3
REV. 6/27/2018 INSTAX-ADFD02
CONNECTIONS TO BE MADE
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the
Red
wire to the accessory wire.
Note:
If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires on the AX-ADFD02 harness as well.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
•
If the aftermarket radio has a mute wire and the vehicle is equipped with SYNC, connect the
Brown
wire to it. If the mute wire is not connected, the radio will turn off when SYNC is activated
.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
• Tape off and disregard the following (5) wires, they will not be used in this application:
Blue/White
,
Green
,
Green/Black
,
Purple
,
Purple/Black
From the AX-ADFD02 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2)
Red
wires to
accessory power.
• Connect the
Blue
wire to the power antenna wire.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative output.
• If the vehicle is equipped with SYNC, and desired to be retained, connect the
Red
and
White
RCA jacks labeled “RSE/SYNC/SAT” to the audio AUX-IN jacks.
• If the vehicle is equipped without SYNC, and the AUX-IN jack is desired to be retained,
connect the
Red
and
White
RCA jacks labeled “FROM 3.5” to the audio AUX-IN jacks.
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If the ASWC-1 will be
used, please refer to the ASWC-1 instructions for radio connections and programming. Disregard
the harness that comes with the ASWC-1.
DIN jack:
The DIN jack is to be used with the optional AX-LCD (sold separately) to retain SYNC information.
Continue to Installing & Programming the AX-ADFD02
Содержание AX-ADFD02
Страница 7: ...7 REV 6 27 2018 INSTAX ADFD02...
Страница 15: ...7 REV 6 27 2018 INSTAX ADFD02...