Axor Microspeed 60, Руководство пользователя

Страница: 42 / 44

MICROSPEED
42
REV 04/05
It is possible to run the Microspeed using digital PWM
commands. (Frequency signal in PWM plus direction
signal DIR) (see figure).
Such logic signals must be furnished to the Microspeed
by a controller
which must be able to elaborate the motor's
speed ring
and possibly the positioning ring.
(The signals high logic level PWM and DIR must be
b5Vdc and 24Vdc max.).
The Microb comes predisposed to function with
supported logic signals, also highlighted in the figure
below.
--With High PWM logic signal and any DIR logic value
you have zero output voltage bM and -M.
(Motor output terminal).
--With logic signa PWM = Low and DIR = Low you
receive clockwise motor rotation.
--With logic signal PWM = Low and DIR = High you
receive counter-clockwise motor rotation.
8.4 Command with Pwm+Dir. (option)
1 Drive OK, Open Collector output 100mA Max. (Normally
closed, opens when in protection mode).
3-12 GND Common zero signal
4 Auxiliary output v10V, 4mA.
5 Auxiliary output voltage -10V, 4mA.
6 Enable (+10/30 Volt drive enabled)
7 PWM input Frequency
8 DIR input Direction
Note: The other pins connector are N.C
For the leds indicator, in this option,see Chapter 3.1
The only active adjustemente in this option are RIN and
RIP.
Signal connector description