13
5
Settings Menu
Introduction
The settings menu displays the current state of each HCS setting and
allows you to change or adjust it. Settings can be changed using the front
panel of the Synapse frame (SFR18 or SFR08) or with Cortex. Also the
Synapse or Cortex control panels can be used. Please refer to chapter 3
for information on the Synapse front panel control and Cortex.
Note:
All items preceded with a #-sign are part of the presets.
Disk-Protect
When set to
On
, the
Num-Clip
,
Out-Frmt
,
Compression
and
Include-Anc
are set to
read-only
, because changing one of these
setting will result in erasing the disks. Default this is set to
On
.
Out-Frmt
With
Out-Frmt
you can set what the output should be. This setting is
only used for the delay options. This will not up/down/cross convert your
input signal. Possible settings are:
1080i60
1080i50
720p60
720p50
SD525
SD625
Note:
Can only be changed when
Disk-Protect
is set to
Off
.
Changing this setting will result in erasing the disks!
H-delay
Here you set the H delay offset of the output timing with respect to the
chosen reference in pixels. Range varies with the selected standard. For
example 0..1919 pixels in 1080i50.
V-delay
Here you set the V delay offset of the output timing with respect to the
chosen reference in lines. Range varies with the selected standard. For
example 0..1124 lines in 1080i50.
Compression
Here you set the bitrate of the JPEG2000 compression. Range is 150Mbps
to 25Mbps in steps of 25Mbps.
Note:
Can only be changed when
Disk-Protect
is set to
Off
.
Changing this setting will result in erasing the disks!
Include ANC
Here you set which part of the ANC data is recorded and therefore
transparent on the output. You can choose None, H_only, V_only or
H_and_V. Note this uses diskspace and shortens the maximum delay.
Note:
Can only be changed when
Disk-Protect
is set to
Off
.
Changing this setting will result in erasing the disks!