Page 2
1315 Directors Row Suite 107 Fort Wayne, IN 46808
⁞
(260)496-9668
⁞
www.atterotech.com
2.1– Mounting
A typical installation will involve mounting the wall plate
into a pre mounted wall box or mounting bracket. Before
installation, make sure the wall box where the C1 is to
be installed is pre-wired with a suitable cable back to a
PoE-enabled network switch or mid-span injector. If a
mid-span injector is being used, the cable should be
connected to the port that supplies both Ethernet and
power (refer to the devices manual if unsure which port
is which).
Attach the network cable from the switch/mid-span
injector to the Ethernet port of the C1. If the switch or
mid-span injector is already running and PoE is enabled,
the unit will power up and the green status LED on the
front of the device will turn on.
With the cable attached, carefully place the C1 into the
wall box taking care to not trap the cabling. Once in
place, secure it with the screws provided. Once the unit
is secured in the wall box, fit the Decora plate and secure
it with the screws provided.
The C1 comes in a single gang US Decora style form
factor and may be mounted in most US single old and
new work back boxes and mud-rings. Given the single
gang size, the C1 may be mounted in larger gang boxes
with other single gang form factor products to provide
flexible AV system modularity where needed.
*Note:
CAD drawings can be downloaded from the
Attero Tech website. Please contact Attero Tech for any
further product related information that is not
accessible on the website.
Figure 3 - Dimensional Drawing
