Axminster ED16B2, Руководство пользователя

Страница: 7 / 32

General Safety Instructions for Drilling Machines
7
Model ED16F2
Code 505024
Rating Trade
Power 650W 230V
Speed Range 120-2580 rpm
Throat
178mm
Chuck Cap/Type
3-16mm keyless
Chuck Travel 80mm
Max Chuck to Table 680mm
Max Chuck to Base 1,170mm
Diameter of Column 80mm
Table Size
290 x 290mm
Table Tilt
45° - 0 - 45°
Base Size 450 x 270mm
Overall L x W x H 710 x 350 x 1,645mm
Weight 88kg
Model
ED16SB
Code
700101
Rating
Hobby
Power 370W
Speed Range (5) 460-2890rpm
Throat 127mm
Chuck Cap/Type 16mm keyless
Chuck Travel
60mm
Max Chuck to Table
315mm
Max Chuck to Base 430mm
Table Size 200 x 200mm
Table Tilt 45° - 0 - 45°
Base Size 340 x 210mm
Overall L x W x H 310 x 520 x 840mm
Weight
37kg
Model ED16B2
Code 700100
Rating Trade
Power 650W
Speed Range 120-2580 rpm
Throat
178mm
Chuck Cap/Type
3-16mm keyless
Chuck Travel 80mm
Max Chuck to Table 310mm
Max Chuck to Base 510mm
Diameter of Column 80mm
Table Size
290 x 290mm
Table Tilt
45° - 0 - 45°
Base Size 450 x 270mm
Overall L x W x H 710 x 350 x 1,015mm
Weight 82kg
Model
WD13L
Code
700099
Rating
Hobby
Power 250W
Speed Range (5) 600 - 2,500rpm
Throat 105mm
Chuck Cap/Type 13mm keyless
Chuck Travel
50mm
Max Chuck to Table
215mm
Max Chuck to Base 370mm
Table Size 160 x 160mm
Table Tilt 45°-0-45°
Base Size 290 x 180mm
Overall L x W x H 240 x 470 x 735mm
Weight
20kg
Specification
may have been used in setting up operations and put
them away in their correct stowage positions.
7. Try to arrange the drilling operation so that the drill
tip does not come in contact with the table.
8. Always allow the drill to stop before removing
drillings or swarf from around the job or the table.
9. NEVER remove ‘flying’ swarf strands from the drill
whilst it is turning.
10. It is a good precaution to wear eye protection
when drilling, especially using small drills, or very
hard material that produces small chips.
11. It is not a good idea to wear gloves when
operating a drill press.
12. After the job is completed, remove all tools and
accessories from the machine, check that drill bits are
still sharp and re-use able.
13. Clean the machine down thoroughly, including
removing coolant or cutting compounds from the
drill table.
14. Lightly coat all metal surfaces with a light oil
coating.
15. Disconnect the machine from the supply. Secure
the cable/plug clear of the floor.