Axminster BTP210F, Руководство пользователя

Страница: 21 / 32

W H I T E
A X M I N S T E R
W
20
Maintenence...
• The table surface and feed-in / feed-out rollers should always be kept clean of resin. Dirty
feed-in rollers and feed-out rollers (24) have to be cleaned In order to prevent the motor from
over heating, (See fig 28) regularly check that no dust has accumulated on the ventilation
apertures of the motor. After a prolonged period of operation, users are recommended to have
the machine checked by an authorized service engineer to see over the job.
The cutter head, clamping devices, knife supports and knives used on the machine must be
freed from resin regularly as a clean tool improves the cutting quality. This can be done by
soaking the clamping devices, knife supports and knives for 24 hours in paraffin, white spirit or
commercially available resin remover.
If you find that the machine is not performing as it should please contact “Axminster Power Tool
Centre” by phone on
0800 371822.
Troubleshooting...
1. Machine cannot be switched on. Cause:
- No main voltage. Check power supply.
- Carbon brushes worn. Take the machine to your supplier or Distributor.
2. Machine switches itself off when idling. Cause:
- Mains failure (check mains back-up fuse).Renew fuse.
3. Machine stops while planing is in progress. Cause:
- Blunt knives or excessive feed rate. Replace or sharpen knives, or reduce feed rate.
4. Speed drops while planing is in progress. Cause:
- Cutting depth too great. Reduce cutting depth.
- Feed rate too fast. Reduce feed rate.
- Blunt knives. Sharpen or replace knives.
5. Unsatisfactory finish. Cause:
- Blunt knives. Sharpen or replace knives.
- Uneven feed. Plane with constant pressure and reduce feed rate.
- Not connecting to dust extractor unit (not supplied). Connect to it.
6. Chip ejection blocked while planing or thicknessing is in progress. Cause:
- No dust extractor unit. Essential to use a dust extractor unit while using the machine.
- Wood too damp.
7. Uneven feeding rate while thicknessing is in progress. Cause:
- Rubber belt too loose. Check the rubber belt, and change it If necessary.
-Clean the dust from the two springs located on the side cover, where a yellow warning label
marked.
Feed in roller Feed out roller
Fig 28
OIL
ventilation
apertures
Oil