Axminster BDS-612, Руководство пользователя

Страница: 16 / 28

Setup/Adjustment
Fig 37
Fig 36
Fig 38
Fig 39
Belt Table adjustment
Step 1 Loosen the four Hex bolts (c)beneath the table
brackets, see fig 37 place a rule up against the sanding
belt and adjust the table until there is a 1.6mm clearance
between the table and the belt, (see fig 33).
c
Step 2 Place the 90˚ square against the belt and mitre fence,
(see fig 38) to check the table is square then tighten the four
Hex bolts beneath the table.
Step 3 Place the square upright against the sanding belt,
loosen the bolt to the side of table and adjust the table
16
Step 4 Check the pointer is reading “ZERO” on the scale, if
not, loosen the Phillips screw and adjust the pointer until
correct, see fig 40.
Fig 40
Tracking the Belt
NOTE1 All directions are given from the view point of the
operator standing behind the drive drum end looking down
the length of the machine. The tracking control works as
follows:- turning the tracking adjuster clockwise will track
the belt to the right, anti-clockwise will track the belt to
the left, see fig 41.
DO NOT make large adjustments, and
remember the belt may take some time
to react to your alteration. Little by
little is a good maxim to observe when
carrying out tracking operations.
NOTE 2 Using your hand, roll the belt towards the drive
drum end, check that the belt stays in the middle of the
table, if not, adjust the track control slightly, and move the
belt again, continue until the belt runs down the centre of
the linishing table.
angle, until it’s perpendicular to the sanding belt, see fig 39.
Retighten the bolt.