ASSEMBLY
ILLUSTRATION AND PARTS DESCRIPTION
6
Fig 04
Fig 05
If you are intending to use the 80mm faceplate (B) you
will need to remove the four prong drive centre (F) from
the headstock. Locate the push rod (H), insert it through
the headstock spindle to remove the drive centre, see
fig 04.
Insert the push rod (H) into one of the pre-drilled holes
on the headstock spindle. Screw the face plate onto the
spindle thread, place a spanner (I) over the faceplate
boss and while holding the push rod, rotate the spanner
clockwise to nip-up the face plate, see fig 05-06
Mounting the Faceplate
Fig 06
Faceplate boss
Pre-drilled hole
Loosen
Tighten
Tailstock barrel adjusting grub
screws, to take up any play in the
barrel.
Motor plate clamping bolt, loosen
& press down motor assembly to
increase tension to the belt then
retighten.
Control box - On/Off switch (A),
power LED light (B), speed control
dial (C) and power switch (D)
B
D
C
A
H
H
B
F
