SPECIFICATION
5
ASSEMBLY
Please take some time to read the section entitled
“Illustration & Parts Description” to identify the
various parts of your machine so that you are familiar
with the terminology we will use to enable you
to set up and operate your table lathe safely and
correctly.
The machine and its accessories will arrive coated with
corrosion preventative grease. This will need to be
cleaned from the machine, its components and acces-
sories prior to it being set up. Use proprietary degreaser.
Wear overalls, coverall and eye protection before clean-
ing.
After cleaning, lightly coat the machine with a thin
layer of light machine oil. N.B If you used paraffin/
kerosene make sure you apply this thin film sooner
rather than later.
95% of the machine comes fully assembled, all that
remains is to fit the four prong drive centre (F), the
live revolving centre (G), the tool rest/s (C or D) and
connect the motor and power cables to the rear of
control box.
Continues Over...
Code 107699
Model AW205WL
Rating Workshop
Power
300 W 230V 50Hz 1 Ph
Fuse
F5AL250V (5 amp)
Spindle Thread
1” x 8 tpi
Spindle Speed
750-3200 rpm
Taper Tailstock
1 MT
Distance Between Centres
330 mm
Max Diameter over Bed
205 mm
Tool Rest Stem Diameter
12 mm
Overall L x W x H
730 mm x 150 mm x 310 mm
Weight
20 kg
Fig 01
Headstock
Tailstock
F
G
Fig 02
Mount the tool rest into the banjo arm mounting hole
and secure with the locking handle.
C
D
Fig 03
Power cable
Motor cable
