Operating Instructions
15
Remove the
filter cartridge
Testing the Extractor
Reduced Suction Performance
Connect the extraction hose/s to the extractor’s inlet.
After a period of time dust, sawdust and shavings can
build up causing blockages and reduced suction
performance. Carry out the following checks to keep
your extractor working at peak performance.
• Remove the micron filter bag and check for signs of
build up of sawdust and clean with an ‘M’ class vacuum
cleaner.
• If you have the cartridge filter fitted, move the shaker
paddle handle back and forth to remove any built up
dust and debris from inside the filter.
• Check the hose/s for blockages.
• Check the dust collecting bag and empty if full.
• After a period of time remove the cartridge filter if
installed and using a ‘M’ class vacuum cleaner clean the
interior and exterior of the filter.
IF THE EXTRACTOR FAILS TO
START UP OR THERE ARE ANY
OTHER STRANGE NOISES APART
FROM VIBRATION SOUNDS,
CONTACT THE “TECHNICAL SALES”
FOR SUPPORT.
PHONE: 03332 406406
EMAIL:
ALWAYS WEAR A DUST MASK AND
EYE PROTECTION.
DISCONNECT THE POWER SUPPLY
FROM THE MAINS!
WAIT UNTIL IT’S UP TO FULL
SPEED AND CHECK FOR SIGNS
OF VIBRATION, IF ALL IS WELL
SWITCH OFF AND WAIT UNTIL
THE EXTRACTOR HAS COME TO
A COMPLETE STOP.
NOTE: ALWAYS TURN ON/OFF THE
EXTRACTOR BY THE NVR CONTROL
SWITCH NOT THE MAINS SWITCH!
CONNECT THE POWER SUPPLY
TO THE MAINS AND SWITCH ON!
WARNING! MAKE SURE CHILDREN
ARE KEPT AWAY FROM THE
EXTRACTOR WHILE IN OPERATION.
NVR ON/OFF
control switch
