Assembly
11
11. Remove the nut and washer from one of the Hex bolts (k)
and place safely aside. Offer up the square outlet on the
collector (12) with the outlet on the extractor assembly (13).
Line up the holes, insert the Hex bolt through the top centre
hole and replace the washer and nut and finger tighten. This
helps to support the collector for the next step, see figs 24-25.
12. Line up the holes in the support angle bracket (3) with the
threaded holes to the side of the collector assembly (12) and
secure in place with two 5/16" Hex bolts (h), see fig 26.
Fig 24-25
k
Square outlet
Fig 26
13. Introduce the remaining Hex bolts (k) through the seven
holes in the extractor/collector’s square outlets and securely
tighten with two spanners, see figs 27-28-29.
14. Put to hand the tube handle (7), the two Hex countersink
screws (l) and the 5mm Hex key (a). Line up the holes in
the tube handle (7) with the threaded holes on top of the
mounting brackets, see fig 19 introduce the countersink Hex
Fig 27-28-29
k
screws (l) down through the holes into the mounting brackets.
Securely tighten with the 5mm Hex key, see 30-31-32.
Fig 30-31-32
l
a
7
h
3
Continues Over....
