Assembly
8
Please read through the section entitled Parts Identification
and Description, this will enable you to more readily identify
those parts of the cyclone extractor.
Please note: some of this assembly
procedure is best accomplished by two
persons. Although the tasks are not
impossible, some of the items are heavy
and awkward, and a mishandling error could
cause injury. Please think about what you are
doing, your capabilities and your personal safety. We have added
the ‘two person symbol’ to any operation that we recommend
should be a two person task.
Unpack all the boxes and check all the components listed in
the “What’s Included” section. If any parts or components are
missing, please contact our Customer Services Department
using the procedures and telephone numbers listed in our
catalogue.
Please note: on occasions the packing list is not strictly adhered
to. Please check all the boxes, packets etc. to make sure that all
the parts have been accounted for.
PLEASE RECYCLE ANY UNWANTED
PACKAGING RESPONSIBLY!
Having unpacked the boxes, put all components where they are
readily to hand.
1. Locate the two extractor bases (1-2), tube support bars (3),
upright supports (4), castor wheels (10) and the 5/16" unc Hex
bolts (h) (short). Put the two extractor bases together and line
up the pre-drilled holes. Secure the bases with four Hex bolts
(h), two on top and one either side of the base assembly, see
figs 01-02-03.
Fig 01-02-03
1
2
h
h
2. Turn the base assembly over, put to hand the four castor
wheels (10), line up the holes in the brackets with the
pre-drilled holes to the extractor’s base and secure with
sixteen 5/16” unc Hex bolts (h) (short), see figs 04-05-06.
Fig 04-05-06
10
2
1
h
3. Locate the two extractor wheels (8), 1/2" locking nuts (c),
nylon washers (d), thin washers (e), large washers (f) and 1/2"
large Hex bolts (m). Place a large washer (f) over the 1/2” Hex
bolt (m) and slide the bolt through the centre hole to the front
of one of the wheels (8). Turn the wheel over and slide on a
nylon washer (d) then a thin washer (e) down over the thread
of the Hex bolt, see fig 07-08.
4. Insert the Hex bolt thread (m) through the large pre-drilled
hole to the rear of the extractor’s base and secure the wheel
assembly with the locking nut (c), see fig 09.
