Axminster Trade AT50LP Ultimate Edge, Оригинальное руководство пользователя

Страница: 10 / 24

Setup/Adjustment
10
Tracking the Belt
Setting the Linisher Angle
CONNECT THE MACHINE TO THE
MAINS SUPPLY!
KEEP WORK AREA AS UNCLUTTERED AS IS
PRACTICAL. UNDER NO CIRCUMSTANCES SHOULD
CHILDREN BE ALLOWED IN WORK AREAS.
Fig 16-17-18
1. Press the ‘Green’ “ON” button, see fig 15 then track the belt as
described below.
Fig 15
3. Once complete, press the ‘RED’ button to stop the machine.
2. Turn the ‘Tracking Control Knob’ until the belt is centred
on the platen, see fig 16-17-18.
NOTE: Don’t make sudden adjustments otherwise you
may over correct. Make small adjustments.
The linisher can be pivoted to the required angle by loosening
the two button Hex screws, see fig 06 on page 06 then lower the
linisher to the required angle, see fig 19-20. Re-tighten the Hex
screws to secure the setting.
Fig 19-20
Making small adjustments to centre
the belt on the linisher
Turning the tracking knob anti-clockwise
moves the belt to the right
Turning the tracking knob clockwise
moves the belt to the left