Axminster Trade AT508WL, Руководство пользователя

Страница: 20 / 32

Operating Instructions
20
Alignment Centre
The alignment centre (H) is a simple tool as it has a
double-ended taper that can be used on any woodturning
lathe with a sliding or rotating headstock that has a 2MT
spindle and tailstock fittings. Simple to use, just insert the tool
firmly into the headstock spindle taper as you would a drive
centre, loosen the headstock clamp, bring the tailstock up to
the other tapered end and insert into the tailstock barrel. Lock
the tailstock to the bed, then tighten the tool into place by
using the tailstock barrel hand wheel, but not too much! Lock
the headstock onto the bed. Your two tapers are now aligned
as near as they can be on a woodturning lathe. Slide the tail-
stock back and remove the tool from the headstock spindle
taper, see fig 65-66.
Fig 65-66
Alignment tool
Headstock Tailstock
Remove tool
Unlock Tailstock
Alignment tool
Turn wheel
to tighten tool
(Not to tight)
Clamp headstock Clamp Tailstock
H
Digital Display 1.5V SR44 Battery
Fig 67
If the digital display starts to ‘FLASH’ the battery will need to
be replaced. Follow the instruction below:
1. To change the battery on the tailstocks digital display,
open the displays protective cover and slide the battery cover
to the right. Remove the discarged battery and recycle it at a
environmentally compatible recycling facility.
2. Insert a new 1.5V battery into the compartment, positive
side facing down. Replace the battery cover.
Battery cover
I
O
I
O
I
O
I
O