Axminster Trade AT508WL, Руководство пользователя

Страница: 11 / 32

Assembly
11
Setup 3 ( mounted to side of the lathe bed)
The extension bed can be mounting to one side of the lathe
bed, this feature allows you to use the headstock at a set angle
for turning bowls and gives the user more flexibility.
Position the extension bed so the holes line up with the ones
on the mounting plate and secure in place as described on the
previous setups, see fig 30-31-32.
Fig 30-31-32
Mounting plate
Drive Centre & Live Centre
1. Locate both live and drive centres (I and G). Locate the
spindle locking pin (P), rotate the spindle until the machined
hole on the shaft lines up with the spindle collar access hole.
Insert the locking pin to lock the spindle and undo the two
locking grub screws on either side of the boss, see fig 33. Place
the supplied spanner (C) over the boss and remove the face
plate, place safely aside, see fig 34. Clean all traces of oil and
greese from the drive/tailstock spindle barrels and live/drive
centres/morse tapers, see fig 35-36.
Fig 35-36-37-38
2. Insert drive centre Morse taper (G) into the headstock
spindle and repeat the process for the live centre (I) into the
tailstock barrel. Make sure firmly home, see fig 37-38.
Fig 34
G
I
Fig 33
Grub screw
P