Axminster Trade AT170E, Оригинальное руководство пользователя

Страница: 13 / 32

13
Assembly
Extractor Filter
1. Locate the filter assembly ( 6-26) filter retaining belts (8-24)
and foam seal bands (7-25).
2. Put to hand the wide foam seal band, peal back the paper
backing, position the end of band up against the underside of
the upper lip on the extractor housing and firmly press down
to secure in place. Carefully peal back the backing guiding the
seal band round the extractor until it overlaps, use a knife to cut
off any excess, see fig 25-26-27.
Fig 25-6-26-27
3. Go round pressing down the band to make sure it’s stuck
firmly down. Locate the filter assembly (6-26), lower the filter
down over the extractor opening until it’s firmly down, see 28.
4. Straighten the filter retaining belt (8-24), position the belt
around the base of the filter and latch it down to hold and to
seal the filter assembly, see fig 29-30.
Fig 28
Fig 29-30
5. Locate the remaining foam seal band, peel back the paper
backing, position the end of band up against the edge of the
lower lip of the extractor housing pressing firmily down, see
fig 31.
6. Work the band around the extractor as before, find the dust
bag (5-19) and the remaining retaining belt. Open up the dust
bag and place it up and over the lower extractor housing, see
fig 32.
7 25
Paper backing
Upper lip
6
26
24
8