Axminster Craft AC405SS, Руководство пользователя

Страница: 18 / 24

Maintenance
18
Cleaning
1. Remove the scroll saws side access panel and table insert
plate. Using an ‘M’ class Vacuum Cleaner, clean the accumulated
dust from inside the lower housing that included the motor
assembly, rocker arm, lower and upper blade holders, table
and the table insert void, see fig 43-44. 4.
WARNING! WEAR A DUST MASK
AND EYE PROTECTION.
Fig 43-44
Rocker Arm Bearing Bushes
After a period of use it is recommended to lightly oil the upper
and lower rocker arm bearings, see fig 45-46-47.
Fig 45-46-47
Bearing bush
rubber bungs
Bearing bush
2. If you have finished using the scroll saw, clean above and
below the work table and wipe the scroll saw over, see fig 43-44.
3. If the scroll saw is not going to be used for a period of time,
use ‘Ambersil Dry PTFE Film Antistick’, spray, code 952137 over
the work table to prevent the table from rusting and place a
dust sheet over the scroll saw.
4. If the scroll saw is not going to be used for
a period of time, use ‘Ambersil Dry PTFE Film
Antistick’, spray over the work table and place
a dust sheet over the saw.