Operating Instructions
33
Changing the Panel Saw Blade
Changing the Scoring Blade
WARNING!! DISCONNECT THE MACHINE FROM
THE MAINS BEFORE CONTINUING!
Raise the saw blade to it’s highest point. Remove the saw
blade guard. Pull the sliding table locking knob towards
you and slide the table to the side to expose the blades.
Using the spanner and the tommy bar (A) provided, put
the spanner onto the flats on the nut. Turn the saw until
the tommy bar hole (B) is visible. Insert the tommy bar
and turn the saw to allow it to rest against the front edge
of the saw slot, see figs 61-62.
Fig 62
Fig 61
B
A
Spanner
Slacken off the saw nut (remember left hand thread).
Remove the saw nut, then remove the sawplate washer
and the saw blade. Now is a good time to give the
interior of the machine, the dust extraction channels,
etc. a thorough clean. Check the new blade for damage,
missing teeth,sharpness etc. Fit the new blade, ensure
that the teeth are pointing towards the front of the
machine. Put the saw plate washer onto the shaft and
twist on the saw nut. Spin the nut up finger tight and
check the saw is correctly seated.
Tighten up the saw nut, using the tommy bar to hold the
shaft steady. Check the riving knife is aligned with the saw
blade, and correctly positioned, see fig 63.
Fig 63
Using the 8mm Hex key and the tommy bar (A) insert the
Hex key into cap head bolt, turn the scoring saw until the
tommy bar hole is visible. Insert the tommy bar and turn
the saw to allow it to rest against the front edge of the
saw slot. Remove the blade check the new blade for
damage, missing teeth,sharpness etc. then replace the
scoring saw and tighten, see fig 64.
A
Fig 64
Slide the table back until the locking knob pin engages
the pin recess, replace the saw blade guard. When
everything is satisfactory, turn the saw blade once by
hand to check it doesn’t foul anywhere. Reconnect the
machine to the mains supply.
Give the machine a ‘quick’ burst check ( i.e. quick ON-OFF)
to ensure everything is O.K. If everything is satisfactory,
continue to use the machine. Check the old blade for
sharpness, missing teeth, resin buildup, etc., clean if
necessary and send for refurbishment/re sharpening if
required. If the blade is not to be resharpened, clean and
pack away in its stowage case.
Continues Over....
Riving knife
A
Содержание AC250CM
