Axminster Craft AC250CM, Руководство пользователя

Страница: 13 / 56

Assembly Instructions
13
Fig 31
Mount the overhand plane guard arm onto the side of
the out feed table that corresponds to your preferred
handing, then fit the overhand cutter block guard. In the
accessories packet there is a small spring metal plate,
this fits into the overhand guard clamping assembly to
spread the load of the guard clamp onto the guard. It also
prevents the bolt scoring the upper surface of the guard,
fasten in position using the guard lock,see fig 33-34.
Fig 32
Caphead bolt
Mounting bracket
Clamping handles
Planer fence base
Clamp
Fence support bracket
Fig 33-34
Cutter block guard
Guard clamp
Spring metal plate
Plane guard arm
Guard arm clamp handle
Planer/Thicknesser
Locate the fence mounting bracket and fix to the
machine casting as shown in fig 31, using 2 No. M6 x
12mm caphead bolts, depending on your preferred
handing. Introduce the planer fence base into the
bracket; so that the planer fence base slides into the
fence mounting bracket; then secure; position the fence
approximately mid-table, see fig 32.
3) Raise the saw blade to it’s highest point and slide the
fence assembly (A) up against the blade and adjust the
fence guide rail (C) until the pointer reads ‘0’on the scale
then tighten the two nuts beneath the arm rail to secure
the assembly, see fig 30.
Continues Over....
Fig 30
Blade
Pointer
Scale
A