Axminster Craft AC216TS, Оригинальное руководство пользователя

Страница: 24 / 40

Operating Instructions
24
NOTE: BEFORE USING YOUR SAW, GO
ROUND AND MAKE SURE EVERYTHING
IS SECURE, FASTENED DOWN, THAT ALL
TOOLS ARE CLEARED AWAY FROM THE
WORK AREA!
CHECK: THE BLADE FOR SHARPNESS,
MISSING TEETH, RESIN BUILD UP ETC.,
CLEAN IF NECESSARY. CHECK THE BLADE
IS SECURELY CLAMPED IN PLACE (I.E. NOT
LOOSE)!
CONNECT A DUST EXTRACTION
MACHINE TO THE SAW.
UNDER NO CIRCUMSTANCES SHOULD
CHILDREN BE ALLOWED IN THE WORK AREA
AND KEEP TOOLS AND EQUIPMENT OUT OF
REACH OF YOUNG CHILDREN!
CONNECT THE SAW TO
THE MAINS SUPPLY!
Give the machine a ‘quick’ burst check ( i.e. quick ON-OFF) to
ensure everything is O.K. If everything is satisfactory, the table
saw is ready for use.
Feeding the Work by Hand
Start up the saw, wait until it has reached full speed and slowly
feed the timber through using both handles, (making sure to
keep your hands well clear of the blade and using a push stick
for small pieces), until the timber is behind the riving knife.
Switch off the saw, wait until the blade has come to a complete
stop and remove the timber, see fig 85-86-87.
Fig 85-86-87
N
NOTE: Secure larger pieces of timber to
the table by using the hold down clamp.
Cutting Narrow Pieces
Use the small flat surface of the rip fence extension (F) to cut
thin timber narrower that 120mm, note: use a push stick.
The mitre fence (32) can be mounted on either side of the saw
blade in the two 19mm ‘T’ slots, pre machined into the cast iron
table. The mitre fence can be angled from 90˚ to 45˚ degrees,
see fig 88-89-90.
The Optional Mitre Fence
Fig 88-89-90
32
THE BLADE IS SET
AT AN ANGLE
LESS THAN 90˚
DEGREES FOR
BEVEL CUTS
LOCK THE MITRE
FENCE AND HOLD
THE WORK FIRMLY
HOLD THE
WORK FIRMLY
BLADE GUARD