6
PREFACE -
Precautions
1.
AC Fuse -
The AC fuse inside the unit is not user-serviceable. If you cannot turn on the unit, contact the
dealer from whom you purchased this unit.
2.
Care -
Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft
cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards
with a clean cloth. Don’t use abrasive cloths, thinners, alcohol, or other chemical solvents, because they
may damage the finish or remove the panel lettering.
3.
Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION
CAREFULLY.
AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the
voltage requirements printed on the unit’s rear panel. e.g. ~ 110V / 240V, 50/60HZ
The power cord is used to disconnect this unit from the AC power source. Make sure that the plug is
readily operable (easily accessible) at all times.
If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.
4.
Earth –
The unit is defined as Class1 in EN60065 (low voltage directive) and MUST BE EARTHED.
Connect only to a mains socket outlet with protective earth, and only use the power cord supplied.
Finland:
“Laite on Liitettävä suojamaadoituskoskettimilly varustettun pistorasiaan”
Norway:
“Apparatet må tilkoples jordet stikkontakt”
Sweden:
˶
Apparaten skall anslutas till jordat uttag”
5.
Never Touch This Unit With Wet Hands
– Never handle this unit or its power cord while your hands
are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Axium dealer.
6.
Handling Notes
•
If you need to transport this unit, use the original packaging.
•
Do not leave rubber or plastic items on this unit for a long time; they may leave marks on the case.
•
This unit’s top and rear panels may get warm after prolonged use. This is normal.
7.
Speaker Shorts
Under no circumstances should the speaker output terminals of the unit be short circuited, grounded or
connected to another output.
8.
Direct Sun light -
Avoid installing the amplifier in positions where the front panel is exposed to direct
sunlight – may cause control to become sluggish.
9.
Controller Connection -
Never connect more than eight Axium controllers. The supply is internally
fused (self resetting) and may open circuit. Never connect the unit’s 12VDC terminal (‘Bus Run’ port) to
an external power supply.
