25
SECTION 4 -
Menu Navigation: System
This page is displayed after selecting a Preset.
The Preset may be assigned the Page Preset 2
function. This is where the Preset is invoked
when a PG2 contact closure is made on the rear
panel. Once enabled it cannot be disabled unless
re-assigned to a different Preset, or by Restore
default.
Select ‘Set up’ to enable the Preset Setup Mode.
An Axium splash page is displayed followed by
the Home Page. When in the Preset Setup mode
Navigate through all the zones and make
appropriate changes to the standby, volume and
source selections etc. Once all settings have
been adjusted, navigate back to the Preset:
More/System setup/Preset, Select Yes to
complete and exit the Setup Preset Mode, or No if
you want to continue further settings changes.
The ‘Set alarm’ button above navigates to the
Alarm Preset page.
The Alarm time and days that it is to be activated
may be selected.
The Alarm is set only if the Enable is set.
Select the Back arrow to return to the System
settings Page.
The ‘Zone selection’ button above navigates to
the Zones allocation page.
Presets are system wide functions, and other
connected Axium amplifier zones can be included
using the ‘Include All’ or excluded using the
‘Exclude All’ buttons. Alternatively each zone can
be navigated through using the plus and minus
buttons, and if to be included the OK button is
selected.
Select the Back arrow to return to the System
settings Page.
