Page 6
AXIS T92A10 Installation Guide
Install the camera in the housing
AXIS T92A10 comes with a pre-installed 12V DC power supply.
1. The housing is shipped with three black plastic spacers. Use one, two or three spacers between
the camera and holder and make sure that the camera lens is positioned more than 2mm above
the heater and that the cables are not in contact with the heater:
• AXIS P1311 - 1 spacer
• AXIS Q1755 - 1 spacer
• AXIS 210/210A - 2 spacers
• AXIS 211/211A/211M/211W - 2 spacers
• AXIS 221/223M - 1 spacer
2. Secure the camera, spacer(s) and holder with one of the three screws (flathead) and clear
plastic spacer (fig.1).
3. Fit the slots on the holder to the positioning screws (fig.2).
4. The camera should be positioned so the lens is 1-2mm (approx. 1/16 inch) from the housing
window. Slide the holder to a suitable position and tighten the positioning screws when
satisfied.
3
positioning
screws for
holder
heater
positioned here
clear plastic spacer
rectangular
spacer(s)
holder
Axis Network
camera
flathead screw
FIG.1
FIG.2
