AXIS Q6042 PTZ Dome Network Camera
System Options
Enter the host names or IP addresses and port numbers for the primary and secondary mail servers in the fields provided. A
From
email address
is also required. If the mail server requires authentication, check
Use authentication to log in to this server
and enter
the necessary information.
SNMP
The Simple Network Management Protocol (SNMP) allows remote management of network devices. An SNMP community is the
group of devices and management station running SNMP. Community names are used to identify groups.
The Axis product can be configured to support SNMP on the
System Options > Network > SNMP
page.
Depending on the level of security required, select the version on SNMP to use.
SNMP v1/v2
provides the lowest level of security. The community name can be specified as a password for read or read/write
access to all supported SNMP devices. The default password for the
Read community
is public and the default password for the
Write community
is write.
Note
If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.
Traps for SNMP v1/v2
are used by the Axis product to send messages to a management system on important events and status
changes. Check
Enable traps
and enter the IP address where the trap message should be sent and the
Trap community
that
should receive the message.
The following traps are available:
•
Cold start
•
Warm start
•
Link up
•
Authentication failed
SNMP v3
provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see
HTTPS, on page 45
. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to Factory Default Settings, on page 56
.
UPnP
TM
The Axis product includes support for UPnP
TM
. UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disabled under
System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings are configured under
System Options > Network > RTP
.
The RTP port range defines the range of ports from which the video/audio ports are automatically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select
Always Multicast Video
and/or
Always Multicast Audio
to start multicast streaming without opening an RTSP session.
52
