AXIS Q6000-E Mk II PTZ Network Camera
About system options
3. Click
Save
.
4. Repeat steps 2
-
4 until there are four calibration points in the channel.
To improve calibration accuracy, make sure the 4 calibration points are spread evenly over the image and at least one
calibration point is closer to the center of the image. It is not recommended to add points near the edges of the image.
5. Repeat the same procedure for all channels.
6. Select
Finish Calibration
.
Note
If you repeatedly get an error message during calibration, lens and resolution changes may be the cause. You can skip the
affected channel and still be able to point and direct the PTZ camera in the calibrated channels.
Network
Basic TCP/IP Settings
The Axis product supports IP version 4 and IP version 6. Both versions can be enabled simultaneously, and at least one version
must always be enabled.
IPv4 Address Configuration
By default, the Axis product is set to use IPv4 (IP version 4) and to obtain the IP address automatically via DHCP. The IPv4 settings are
configured under
System Options > Network > TCP/IP > Basic
.
DHCP (Dynamic Host Configuration Protocol) allows network administrators to centrally manage and automate the assignment of
IP addresses. DHCP should only be enabled if using dynamic IP address notification, or if the DHCP can update a DNS server. It is
then possible to access the Axis product by name (host name).
If DHCP is enabled and the product cannot be accessed, run AXIS IP Utility to search the network for connected Axis products, or reset
the product to the factory default settings (see
) and then perform the installation again.
To use a static IP address, check
Use the following IP address
and specify the IP address, subnet mask and default router.
44
