AXIS M5065 PTZ Network Camera
Video and Audio
Always verify that the video stream meets the quality requirements for your surveillance purposes after changing the video stream
settings.
About MJPEG settings
Sometimes the image size is large due to low light or complex scenery. Adjusting the maximum frame size helps to control the
bandwidth and storage used by the Motion JPEG video stream in these situations. Setting the frame size to the
Default
setting
provides consistently good image quality at the expense of increased bandwidth and storage usage in low light. Limiting the frame
size optimizes bandwidth and storage usage, but may result in poor image quality.
About stream profiles
A stream profile is a set of predefined stream settings including resolution, compression, frame rate and overlay settings. Stream
profiles can be used:
•
When setting up recording using action rules. See
•
When setting up continuous recording. See
About continuous recording on page 36
•
In the Live View page – select the stream profile from the
Stream profile
drop-down list.
To create a new profile or modify an existing profile, go to
Setup > Video & Audio
>
Stream Profiles
.
To select a default stream profile for the Live View page, go to
Setup > Live View Config
.
About ONVIF media profiles
An ONVIF media profile consists of a set of configurations that can be used to change media stream settings. ONVIF media profiles
can be used by a client to configure media stream properties.
The
ONVIF Media Profiles
page lists all preconfigured profiles. These profiles are included in the product for quick setup. You can
add, modify or remove ONVIF media profiles from this page.
About camera settings
The
Video & Audio > Camera Settings
page provides access to advanced image settings for the Axis product.
About capture modes
Capture mode defines the maximum frame rate available in the Axis product and affects light sensitivity. A capture mode with a high
maximum frame rate has reduced light sensitivity and vice versa.
Capture mode is set the first time the product is accessed. Select the desired capture mode and click
OK
.
Important
Changing capture mode when the product has been configured is not recommended as most other settings will be either
removed or reset.
To change capture mode, follow these steps:
1. Go to
Setup > Video & Audio > Camera Settings
.
2. Select the new capture mode.
Note
When the capture mode is changed, the camera needs to reboot for the changes to take effect.
16
