Axis AXIS M1011, Руководство по установке

Страница: 12 / 15

Page 12 Axis STS Network Camera Installation Guide
Radio Transmission Regulatory Information & EMC
This equipment generates and radiates radio frequency energy, and must be installed and operated while
maintaining a minimum body-to-camera distance of 3 feet (1 meter).
If this equipment causes harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures: Re-orient or relocate the receiving antenna. Increase the separation
between the equipment and receiver. Connect the equipment to an outlet on a different circuit to the
receiver. Consult your dealer or an experienced radio/TV technician for help. Shielded (STP) network
cables must be used with this unit to ensure compliance with EMC standards.
Tested to comply with FCC Standards FOR HOME OR OFFICE USE. This product must be installed and used
in strict accordance with the instructions given in the user documentation. This Axis product complies
with the following radio frequency and safety standards:
AXIS M1011
USA -
This equipment has been tested and found to comply with the limits for a Class B computing
device pursuant to Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection
against such interference when operated in a commercial environment. Operation of this equipment in a
residential area is likely to cause interference, in which case the user at his/her own expense will be
required to take whatever measures may be required to correct the interference.
Canada -
This Class B digital apparatus complies with Canadian ICES-003.
Europe -
This digital equipment fulfills the requirements for radiated emission according to limit B
of EN55022, and the requirements for immunity according to EN55024 residential and commercial
industry.
Japan -
This is a class B product based on the standard of the Voluntary Control Council for Interference
from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a
domestic environment, it may cause radio interference. Install and use the equipment according to the
instruction manual.
Australia -
This electronic device meets the requirements of the Radio communications
(Electromagnetic Compatibility) Standard AS/NZS CISPR22:2002
AXIS M1011-W/M1031-W (Wireless)
USA -
Federal Communications Commission FCC
This device complies with Part 15 of FCC Rules. Operation of the device is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference that may cause undesired operation.
Information to user
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Caution - modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.