PESHEAT2V01
2016-01-08
23
Keeping the accuracy of preset
flow temperature (hysteresis),
o
C
(only for mode On2)
o
C
the maximum allowed value of
flow temperature (
threshold value
of
protection),
o
C (only for mode
On2)
o
C
Software version number*
LCD segment test*
Notes:
1.
The displayed parameters list can be shorter depending on the selected modification, and a
meter configuration (parameters, inappropriate for the given configuration will not be shown).
2.
Marked with "*" parameters values can be modified only by the manufacturer (replacement
possibility is protected by calibration seal). These parameters are displayed only for
information
3.
Parameters 23... 29 will be displayed only if the meter is completed with the mains supply
module. It can be modified (changed) in "SET" and "INF" display modes
4.
Displayed parameter values, for example. "1.00-2" are given in exponential form:
There: X.XX E XX
For example: value 1,25E-2 = 1,25*10
-2
= 0,00125.
Parameters, listed in Table 7.1 should be set up as
shown in Fig. 7.2:
Select the parameter to be modified, then press
hold button
until parameter value starts blinking –
and
alteration mode is entered.
Select required position by pressing button
.
Shortly pressing button
, set the required value (or
select from list). Save changes by holding button
pressed and return to display mode.
Value of exponent
Value of base