2019-10-17 | Technical improvements, changes in design, printing- and other errors expected.
13
3. Basic functions
After having switched on the EoC modem, the LEDs should indicate the following states:
∂
The green Power LED is lit.
– After approx. 10 seconds, the LEDs are lit/flashing as follows:
– EoC LED green (flashes in case of data traffic)
– LAN LED green (flashes in case of data traffic)
– WiFi LED green (if WiFi is switched on) green (flashing in case of data traffic)
3.1. Standby mode:
The EoC modem switches after several minutes without data traffic to the Standby mode. The Power LED is
flashing green then.
3.2. EoC Reset button:
The EoC reset button is used for the following functions:
∂
reset to the factory default setting (press > 10 s).
∂
delete the network key (press 5…8 s)
∂
generate a private network (press <1 s)
3.3. EoC Reset Function:
Hold the reset button depressed for one second using a bent up paper clip, in order to reset the device to the
factory defaults.
The EoC reset button does not work in standby mode.
3.4. WiFi WPS/Reset button:
The WiFi WPS/Reset button is used to reset the WiFi router to the factory IP address 192.168.100.111
∂
The WiFi WPS/reset button does not work in standby mode.
3.5. WiFi access:
Switch WiFi ON. WiFi is active:
∂
Network name (SSID) = EoCxxxxxx
∂
(xxxxxx = last six signs of the MAC adress, you find on the type label of the modem)
∂
Encryption = WPA2
∂
Password = 0000000000000000
You should change the default password to secure your WiFi network!
