AXIL MD0277E, Руководство пользователя

Страница: 23 / 80

3. Press the SET button fi rst and hold it down while pressing the POWER button on your remote control till the
LED under the corresponding device button solidly light. Release both buttons, LED become light starts fl ashing.
The automatic code search begins.
4. Every fi ve codes are transmitted, there is a 5.0 seconds period between each transmission, approx. 9 min. in
total. LED blinks fi ve times for each transmission.
5. When your device switches off, then the correct code range has been found.
6. Immediately press the respective DEVICE key to auto search within these fi ve codes. LED blinks
7. Now using the original remote control or device front panel to switch the device ON.
8. When your device switches off, the correct code has been found.
9. Press the respective DEVICE button to stop/store. LED is off
10. During the step 6, SET button can be pressed to return the Step 4.
11. During the step 3~4, the auto search can be exited by pressing the respective DEVICE button twice.
Check whether all applications of your device can be operated with the remote control keys. (see
“Verify setup“)
Tip in Quick search and Auto search:
-
Some devices can not be on/off by remote control, in this case, the device may effect the PLAY function to
indicate the correct code has been found.
- The search direction can be changed by pressing the CH+/- button.
- All the function buttons except POWER and PLAY can be verifi ed without existing the quick search mode. The
function button can not work when the LED blinks.
- If the device locked, LED blink three times and then exit the setup.
If no button was pressed for more than 30 seconds, setup stops automatically, the LED goes out.
Verify setup
Setup completed, check whether it was successful by following the steps below:
• Switch on the device to be controlled.
• Aim your remote control at the device and press the respective DEVICE button (e.g. TV)
• Now, on your remote control, check the buttons applicable for the device. For example: Press the POWER button
to see whether it switches the device off.
• The LED under the corresponding device key will fl ash once if there is the signal transmitted from the function
button.
Should your remote control still not work, check the codes list again and repeat the setup procedure (Direct code
setup or code search) until you fi nd the correct code.
Note the code
Make a note on this manual, it will save your time if you ever need to setup again. If you have forgotten to note
the code you can still “read” the code from your URC in the below way.
Read device code
The LED will fl ash corresponding to the numerals of the 3-digit code. For example: For code 231, the LED would
fl ash two times, then three times, then once.
Proceed as follows:
1. Press the DEVICE button of the device of which to display the code.
2. Simultaneously press and hold the SET button and 1. Release the two buttons. The LED under the corresponding
device button lights up; its fl ashing indicates the fi rst digit of the code.
3. To display the second digit, press and hold the SET button and 2 simultaneously. The LED under the corresponding
device starts fl ashing. its fl ashing indicates the second digit of the code.
4. To display the third digit, press and hold the SET and 3 simultaneously. The LED under the corresponding device
starts fl ashing. its fl ashing indicates the third digit of the code.
5. Repeat steps1~4 to fi nd the codes of other devices
LED does not light up = 0.