20.00kg on the weighing hook, and press Z/T when
the weight has steadied.
4.
The display will flash “PASS” then return to normal
weighing mode. Adjustment is complete!
X. Troubleshooting
•
Problem:
Scale will not turn on
•
Solution:
Check the batteries and battery contacts.
•
Problem:
Displayed weight fluctuates randomly
•
Solution:
Make sure to hold the device as still as
possible or hang it from a fixed point. In some cases,
nearby radio wave emitting devices can cause
fluctuations.
•
Problem:
Displayed weight is inaccurate
•
Solution:
Perform a calibration adjustment. If
you are still having trouble, contact our warranty
department.
XI. Error Codes
1. OUTZ
- Zero point has drifted out of the acceptable
range. Try to perform a calibration adjustment. If the
problem persists, the load cell may be permanently
damaged due to overloading.
2. EEEE
- Overload. The maximum capacity has
been exceeded. Remove the extra weight to avoid
permanently damaging the load cell.
3.
+ -
- Batteries are low. Replace the batteries.
XII.
Specifications
