www.AVuno.com
www.AVuno.com
| Page 9
| Page 8
CONNECTIONS
CONNECTIONS
CONNECTING AUDIO SOURCES
•
Using the lead supplied with the music source (in the majority of cases it's 2 RCA phono plugs
to 2 RCA phono plugs) connect the output of the source device to the relevant input on the
receiver. For example take the output of a CD player and plug it into the CD input on the
receiver and you can listen to it by selecting the CD button on the remote or front panel. This
applies to any audio source you wish to connect.
CONNECTNG THE SPEAKERS
•
Loosen the binding posts
•
Strip about 5mm from the outer insulation of the speaker cable and insert into the binding
post.
•
Tighten the knobs on the binding posts securely, ensuring that the cables are not touching
and are connected so that the polarities on the speaker terminals match the polarity on the
receiver. i.e “+ to +” and “- to - “
•
Alternatively you could connect the speakers to the receiver using banana plugs again
ensuring the wires are not touching and that the polarities on the receiver and speaker match.
•
Position the speakers for maximum enjoyment. It is recommended that the speakers are set 2
to 3 metres apart and are at a 45 degree angle to the central listening point in the room.
CONNECTING THE FM & AM ANTENNAS
•
The FM and AM antennas connect to their respective inputs at the rear of the receiver.
•
The AM loop antenna should be fully unwound and by pressing on the spring loaded tabs you
can insert the bare ends into the socket. Releasing the tabs secures the connection of the
antenna.
•
The FM antenna plugs into the coaxial socket .
•
The antennas should then be positioned until the best possible signal is obtained.
CONNECTING THE POWER
•
Please ensure that you connect all your other electronic components and are certain that the
speakers are correctly attached before switching on the unit.
•
Make sure that the power cord is plugged in completely and then switch on.
USING HEADPHONES
•
Using headphones can give you the privacy to enjoy music without disturbing others.
However it is advised that care be taken when doing so.
•
When using headphones you must always make sure that the volume is turned down before
you put them on, then you can adjust the volume to the desired level.
•
It is always advised not to listen at high levels or for extended periods of time.
•
If it causes ringing in the ears then it is recommended to discontinue use.
