Avtech AVR-G5-B, Инструкция по эксплуатации

Страница: 22 / 43

AMPLITUDE CONTROL
When the output is “on”, the output waveform swings between -V
SET
/2 and +V
SET
/2,
where V
SET
is the programmed amplitude. The output voltage between pulses is -V
SET
/2
(not zero). When the output is “off”, the output voltage is zero.
TRIGGER MODES
This instrument has four trigger modes:

Internal Trigger: the instrument controls the trigger frequency, and generates the
clock internally.

External Trigger: the instrument is triggered by an external TTL-level clock on the
back-panel TRIG connector.

Manual Trigger: the instrument is triggered by the front-panel “SINGLE PULSE”
pushbutton.

Hold Trigger: the instrument is set to not trigger at all.
These modes can be selected using the front panel trigger menu, or by using the
appropriate programming commands. (See the “Programming Manual for -B
Instruments” for more details.)
PULSE WIDTH MODES
This instrument has two pulse width modes:

Normal: the instrument controls the output pulse width.

PW
IN
=PW
OUT
: the output pulse width equals the pulse width of the trigger signal on
the “TRIG” connector. The instrument must be in the external trigger mode.
These modes can be selected using the front panel pulse width menu, or by using the
appropriate programming commands. (See the “Programming Manual for -B
Instruments” for more details.)
200 ns to 0.5 sec
0V
0 to 440V
peak to
peak (V
SET
)
+V
SET
/2
+V
SET
/2
22