Avtech AVP321Z, Руководство пользователя

Страница: 10 / 33

INSTALLATION AND SETUP
-6-
STEP 5: On the touch panel of the keyboard controller, click “Conf” to enter the configuration page, and
click (P.T.Z) to make related settings as follows.
●
RATE : Check and select the baud rate the same as the connected speed dome camera
is used.
MODE : Choose the proper camera protocol depending on the camera type.
STEP 6: Then, click “ESC” as many as needed to return to the main menu, and assign the ID of the
camera.
STEP 7: Connect the camera video cable to the DVR for video output and recording, and connect the
camera to power.
2.2.2 Connecting to DVR
You can also connect the camera directly to DVR for pan / tilt / zoom control, but the available camera control is
limited. For details, please refer to “APPENDIX 2 CAMERA CONTROL VIA OUR DVR” at page 27.
The following description is taking our brand’s DVR as an example. For detailed PIN / port connection and DVR
setting to control the speed dome camera, please refer to your own DVR user manual.
RJ11 cable RS-485 Port
RS485-A: Red wire RS485-A: PIN 2
RS485-B: Green wire RS485-B: PIN 3
The RJ11 cable is not supplied in the sales package. Example of RS485 port on the DVR rear panel.
PIN Connection
For 15 PIN D-Sub Connector:
RS485-A: PIN 11
RS485-B: PIN 10
For 25 PIN D-Sub Connector:
RS485-A: PIN 12
RS485-B: PIN 24
Solder Side of
15-pin D-Sub connector
1
9 12 13 14 15
16 17
2 3 4 5 6 7 8
10 11
RS485 -A: PIN11 / RS485-B: PIN1 0
1
15 16 17 18 19 20 21 22 23 24 25 14
2 3 4 5 6 7 8 9 10 11 12 13
Solder Side of
25-pin D-Sub connector
RS485 -A: PIN12 / RS485-B: PIN2 4
D-Sub connector is supplied with the DVR package.
STEP 1: Get a RJ11 cable with the proper length to your connection.
Different RJ11 connector may have different wire layout, so the connection might be different. If you
cannot control the DVR after connection, please reverse the RJ11 cable connection with the DVR.
STEP 2: Remove one end of the insulating coating of the RJ11 cable.
Remove one end of the insulating coating of the RJ11 cable to find the RS485-A and the RS485-B wires,
and remove the insulating coating to reveal the naked wires for further connection.