9
Note:
If you can’t find the camera, make sure your LAN status indicator ( ) is always on, and search
again after 3 minutes.
If you connect two or more cameras to the wireless router, you’ll see many cameras with different IP
addresses after searching. To know which camera you’re configuring, you may identify each with its
unique MAC address.
Note:
The MAC address can be found on the sticker at the rear panel of the camera.
Step3: Select the IP address you want to configure to
show the IP address setting page.
Switch the tab from “DHCP” to “Static”.
The default port number is 88. You may change it
to any value (such as 8080) if the port number of
88 is blocked.
Step4: Select “Apply” to confirm all your changes. Then,
wait till you see “
Done
” or “
Fail
” in “Status”.
Regardless which message you see, proceed as
instructed below:
For
Done
, you’ll return to the new device page.
For
Fail
, select “
” on the top right side. You’ll later
be prompted to select “DDNS” or “Local IP”. Select
“DDNS” and return to the new device page.
