Avtech 14260, Инструкция по эксплуатации

Страница: 13 / 54

INSTALLATION
VISUAL CHECK
After unpacking the instrument, examine to ensure that it has not been damaged in
shipment. Visually inspect all connectors, knobs, liquid crystal displays (LCDs), and the
handles. If the instrument has been damaged, file a claim immediately with the
company that transported the instrument.
The following items should be with the instrument:
1) A power cord.
2) A GPIB cable.
3) Two instrumentation manuals (this manual and the “Programming Manual for -B
Instruments”).
4) One test jig, with a hinged lid.
5) A 2 meter DB-9 control cable.
6) Two 60 cm lengths of SMA-to-BNC cable.
7) Two 60 cm lengths of SMA-to-SMA cable.
8) One AVX-FILT-10NS accessory filter.
9) Units with -F8NS option only: One AVX-FILT-8NS accessory filter.
10)Units with -F12NS option only: One AVX-FILT-12NS accessory filter.
11)Units with -F20NS option only: One AVX-FILT-20NS accessory filter.
POWER RATINGS
This instrument is intended to operate from 100 - 240 V, 50 - 60 Hz.
The maximum power consumption is 57 Watts. Please see the “FUSES” section for
information about the appropriate AC and DC fuses.
This instrument is an “Installation Category II” instrument, intended for operation from a
normal single-phase supply.
CONNECTION TO THE POWER SUPPLY
An IEC-320 three-pronged recessed male socket is provided on the back panel for AC
power connection to the instrument. One end of the detachable power cord that is
supplied with the instrument plugs into this socket. The other end of the detachable
power cord plugs into the local mains supply. Use only the cable supplied with the
instrument. The mains supply must be earthed, and the cord used to connect the
instrument to the mains supply must provide an earth connection. (The supplied cord
does this.)
13