Avtech 14258, Инструкция по эксплуатации

Страница: 7 / 48

SPECIFICATIONS
Model 1 : AVR-EB4-B-NXPB-SOD123W
Recovery type: Reverse recovery
Intended application: High-speed rectifiers
Basic waveform: A positive pulse interrupted by a negative pulse
Pulse polarity: - +
Diode current 2,4 (approx.,
depends on V
DIODE
):
-100 mA to -1 A +50 mA to + 500 mA
Pulse width (FWHM): 2 us 100 us
Maximum duty cycle: N/A
Rise time (10%-90%): 1.2 - 1.5 ns typically N/A
Maximum PRF: 1 kHz
Delay: 80 us after start of + pulse N/A
Coaxial cable to test jig
(supplied):
Two 2 m / 6 feet, RG-58C/U cables.
Supplied test jig
3
: Model AVX-TRR-NXPB-SOD123W, for SOD123W packages
Mainframe connectors: Out: SMA
Other: BNC
GPIB and RS-232 control: Standard on -B units. See http://www.avtechpulse.com/gpib for details.
Trigger required: Ext trig mode: + 5 Volts, 10 ns or wider (TTL)
Gate input Active high or low, switchable. Suppresses triggering when active.
Power requirements: 100 - 240 Volts, 50 - 60 Hz
Dimensions: H x W x D: 100 mm x 430 mm x 375 mm (3.9” x 17” x 14.8”)
Chassis material: cast aluminum frame and handles, blue vinyl on aluminum cover plates
Temperature range: +5°C to +40°C
1)
-B suffix indicates IEEE-488.2 GPIB and RS-232 control of amplitude, pulse width, PRF and delay (see http://www.avtechpulse.com/gpib ).
2) For operation at amplitudes of less than 10% of full-scale, best results will be obtained by setting the amplitude near full-scale and using external
attenuators on the output.
3) Customized jigs available upon request.
4) The amplitude settings should not be relied upon for any degree of accuracy, because the dynamics of the device under test can affect the actual
generated waveforms. Amplitude settings should always be verified by oscilloscope measurements.
7