AVT MAGIC THipPro Lite, Руководство по настройке

Страница: 42 / 158

▪
The POTS INTERFACE pages are displayed only if
there are POTS channels configured on the LINE
INTERFACE page.
▪
The POTS interface parameters for channels
connected to a PABX are configured on the POTS
INTERFACE: PABX page.
▪
The POTS interface parameters for channels
connected directly to the public telephone
network are configured on the POTS INTERFACE:
OUTSIDE LINES page.
▪
The parameters are the same for both variants:
▪ COUNTRY SETTING: Defines the POTS interface’s
impedance. Finding the correct setting is crucial to
minimize echo. Set the country of your location or
use the country of manufacture of the PBX as a
guideline.
▪
WAIT FOR RECEIVED PHONE NUMBER (CLIP)
BEFORE CALL IN SIGNALLING: The calling party’s
phone number is signalled between the first and
the second ringing. Enable this setting the
incoming call should be ignored until the second
ringing. The call will be visible from the second
ringing even if no phone number is detected.
▪
DROP WHEN BUSY TONE DETECTED: Enable if the
system should drop the call automatically when the
disconnected tone (busy tone) is heard on the
telephone line. You may define a custom tone or
the measure the tone in the BUSY / DROP TONE
section.
▪
LOOP-BREAK TIMEOUT: Defines the minimum time
the loop current of the telephone line must be
interrupted for the MAGIC THipPro Lite to drop the
call. Short interrupts are used to signal events in
the network (e.g., initiate call forwarding). Longer
interrupts indicate a problem in the network. When
the timeout is set too low, accidental disconnects
may happen. (default: 300ms)
▪
HOOK FLASH DURATION: A hook flash signals the
network that a device wants to forward a call.
Adjust the hook flash duration if there are problems
forwarding calls.
POTS Interface: PBX / Outside Line (2)
44