10
Programming A Replacement Remote
PLEASE NOTE: your new AVS remotes have already been programmed at the factory for
you!!!
Anytime a new remote is to be programmed, you will also have to reprogram the existing remote other-
wise it will be erased from the receivers memory. For instance, if you lose a remote and think that there is
a chance of someone else finding it and using it on your vehicle do the following step:
1.
Reprogram the remote that you still have in your possession as instructed below. This will delete the
lost remote from the receivers memory so it can not be used by an unauthorized party. Your system
will now only respond to the one remote that is in your possession.
2.
Order a replacement remote from www.airbagparts.com or an AUTHORIZED AVS DEALER.
3.
Once you receive your new remote locate the black push button and red LED light that is next to the
main harness on the receiver. DO NOT unplug the harness!!! It must be plugged in and powered up
in order to be programmed with the remote codes.
4.
Have both remotes ready (your new one and old one). Now hold down the black button on the re-
ceiver for around 10 seconds or until the LED light turns on solid red and let go.
5.
Immediately press the top left button on the first remote until the LED light flashes off then back on.
This confirms that it has received the transmitter code.
6.
Immediately press the top left button on the second remote until the LED flashes off then back on.
7.
Do not press any buttons on the receiver or remote until the LED has completely turned off. Once it is
off check each remote to make sure that the programming was successful. If not, repeat steps 4-7
again.
PLEASE NOTE: the AVS remotes included in this kit
have already been programmed at the factory for
you!!!
Even if the battery on your vehicle dies, the receiver will still re-
PROGRAMMING BUTTON & LED
9
Wiring The Receiver To Any AVS ARC-7, ARC-T7 Or ARC-T9 Air Ride Controller
UP
DOWN
Connecting the AVSREC4 receiver to any of our AVS ARC-T7, ARC-T9 or ARC-7 switch boxes requires three relays, one which
is for safety purposes. If for some reason the receiver was to malfunction while the vehicle is in motion, an accident could
result from it and cause property damage, personal injury or even death! INSTALL THE SAFETY RELAY!!! Adding the safety
relay will disconnect power to the switch box while the ignition key is on.
30
86
85
87
87A
(+) 12 VOLTS
TO BATTERY
GROUND
TAP INTO AN “ACCESSORY” OR “IGNITION” CIRCUIT.
THESE ARE CIRCUITS THAT HAVE +12V ONLY WHEN THE
IGNITION KEY IS TURNED ON. WHEN THE KEY IS OFF OR
OUT OF THE IGNITION THESE WIRES SHOULD NOT HAVE
Compatible With All ARC-T7, ARC-T9 And ARC-7 Air Ride Controllers
30
86
85
87
87A
30
86
85
87
87A
CO
N
N
ECT
TO
TH
E L
IG
H
T BL
U
E W
IRE
O
F TH
E S
W
ITCH
CO
N
N
ECT
TO
TH
E G
RE
Y W
IRE
O
F T
H
E S
W
ITC
H
BO
X
CO
N
N
ECT
TO
TH
E P
IN
K W
IRE
O
F T
H
E S
W
ITC
H
B
O
X
