•
Disable
--
-
Power
LED Flash
es
1 Time
•
Enable ---
Power
LED Flash
e
s
2 Time
s
Test Pattern Generator:
Press and hold the setting button
(
for
4 second
s)
while
powering up the transmitter.
The color bar pattern,
as seen to the right will appear.
When in this mode, you can short press to toggle the resolution.
Quick
press---Select the test pattern timing
•
1080P ---
LED Flash
es
1 Time
•
4
K
---
LED Flash
es
2 Time
This is useful for
checking cabling and for troubleshooting. It will check the
link between the Rx and the display/sink.
pg.
1
3
AVProEdge
~
2222 E 52nd Street N Sioux Falls, SD 57104
~ 1.877.886.5112 ~ +1.605.274.6055 ~
support@
avproedge
.com
Functions & Set
u
p
of t
he Receiver:
PoE
Mode Slide Switch:
(On
the
front
) This is used to select
how you want to
PoE is
to be
directed
.
There are two options (you are choosing where the power is ORIGINATING from):
•
TX (Default)
= You will need to power the TRANSMITTER, the receiver will be powered over the
CAT Cable (Default)
.
•
RX
= You will need to power the RECEIVER, the transmitter will be powered over the CAT Cable
from the receiver
(
This is
called
"Reverse Power")
.
Using the Setting Button:
(On
the b
ack)
The setting button can be pressed in different combinations based
on what you want to do. The status light on the front will flash based on your selection.
The SETTING BUTTON is located just to the right of the symbol, and the SETTING INDICATOR LED is just
to the left of the symbol.
The SETTING BUTTON area looks like this:
Cascade Mode
This mode forces hot plug, which is useful when
"daisy-chaining" extenders. It is also helpful for
troubleshooting if
there
are sync problems with devices.
To set this mode press and hold
the
setting button
(
for
4 second
s
)
:
AC-EX
7
0-444-KIT
BUTTON
LED
