AC-EX
7
0-444-KIT
■
The
Receiver
pg.
1
1
AVProEdge
~
2222 E 52nd Street N Sioux Falls, SD 57104
~ 1.877.886.5112 ~ +1.605.274.6055 ~
support@
avproedge
.com
Back
Front
HDBaseT
PoE Setting
(Choose where PoE
Originates)
RS232
COM & Pass-through)
L/R Out
(PCM Only)
HDMI
In
Micro USB
(Firmware)
IR
In
IR
Out
48V
Ethernet Ports
10/100
Indicator Troubleshooting Lights on the
Receiver
:
POWER
- On
the
front
:
(
Red
)
This is an indicator
that the power is connected. There are only two states for
light:
•
Light Is On = Power supply is connected and functioning.
•
Light Is Off = Power supply is not connected or there is no power present. (In order to have power: check
the power supply, USP, Outlet, etc...)
AV SYSTEM ACT - On the front:
(Blue)
This is an indicator of activity on the link - this light will blink randomly
as data is sent/received.
HDBaseT LINK - On the front:
(Blue)
This is an indicator that that the RJ45 HDBaseT Link is stable. This light
should always be SOLID.
HDMI SIGNAL S
TATUS - On
the
f
ront:
(Blue)
This i
ndicator shows that the HDMI
Sink
is connected.
The states are:
•
Light Is On
(Solid)
=
Sync w/ HDMI s
ink
is
correct
and solid
.
•
Light Is
Flashing
=
The light flashes during the sync process. If it is flashing continuously, you may still
have a picture, but it is indicating that the Rx is correcting a BE (Bit Error) to make the picture show on
the display.
If the
BLUE HDMI
SIGNAL
STATUS LIGHT
is
flashing
AND you have no pic
t
ure
, check the following:
1.
The source. Plug it directly into the display to be sure it's functioning properly.
2.
Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths.
3.
Try Cascade Mode
(See below)
.
4.
If these
suggestions
do not work, enable the "Test Pattern" (See Below). If you see the pattern, the
problem is between
the
Receiver and display/sink
please
try a different s
ink input or HDMI cable
.
5.
Contact
AVProEdge
if these
suggestions
do not work.
